Difference between revisions of "Clamp Colour"
|(One intermediate revision by the same user not shown)|
Latest revision as of 18:14, 1 June 2011
Node Description & Purpose:
The Clamp family of nodes allow you to clamp, or restrict, the values of the colour or scalar coming into the Input between the values specified by the Min input and the Max input. If the value is less than the Min value it's set to the Min value. If the value is greater than the Max value it's set to the Max value. The clamping is done component-wise for colours. Here is an example using a colour, with the following values:
Input.red is -1
Input.green is 0.5
Input.blue is 2
Min value is -0.5
Max value is 1.5
After clamping the colour will have these values:
Input.red becomes -0.5 (-1 was less than the Min value, so it becomes -0.5)
Input.green remains 0.5 (0.5 is between the Min and Max values, so it's unchanged)
Input.blue becomes 1.5 (2 was greater than the Max value, so it becomes 1.5)
Node Type: Function
Min: This is the value used for the minimum clamp value. If the input value is less than this value then the output is set to this value. If there is no node attached to this input then no minimum value clamping is done.
Max: This is the value used for the maximum clamp value. If the input value is greater than this value then the output is set to this value. If there is no node attached to this input then no maximum value clamping is done.
A scalar is a single number. 1, 200.45, -45, -0.2 are all examples of scalar values.